Welcome to myHanse.com the forum for Hanse Yachts owners throughout the world. | |
Modifications for ocean passage sailing (1) |
Post Reply | Page 12> |
Author | |
Kytho
Lieutenant Commander Joined: 05 June 2008 Status: Offline Points: 81 |
Post Options
Thanks(4)
Posted: 21 April 2014 at 17:17 |
This winter I put some efforts into upgrading my Hanse 470e for longer distances. Below and in the next topic I describe some of them (not in order of importance) and provide photographs when possible.
HANDHOLDS I started with what many of you may have done already early on: installing handholds for the helmsman. Measurements and sketches led to the following construction plan. In winter we could finally mount them: There are holders for water bottles built into them (dehydration being a serious issue on long passages). The handholds are bolted into the sidewalls of the cockpit benches from inside. So part of the inner lining had to be cut to drill the holes and insert the screws; these holes were subsequently covered with a mirror. Handrails were also designed and mounted inside the boat. First of all two long handrails on the ceiling on both sides for walking: Each of these was accompanied by a smaller bar further to the side, allowing to hang up nets on the ceiling for fruits and vegetables. In the galley we installed a strong grab pole on the wall towards the aft cabin and one to protect the stove, to which we can belt ourselves when cooking: STORAGE I think that one of the biggest challenges for an ocean crossing will be the problem of where to put all the extra stuff (food, tons of replacement parts, sails, water, etc.). There are so few cupboards and lockers! One solution to this problem is to sacrifice the shower in the main bathroom; we removed it and built boards where we can put boxes with food: The other solution was to install bars along the double bed in the front cabin. These will allow to store large boxes with gear on the bed (which we can anyway not use in rough sea); they will not slide down when the boat heels. The two bars can be removed for normal cruising: Leesails: I attached Tenax buttons on the cabin table and on the seat underneath, so that a leesail can be fastened for a person to sleep there. The two bars bisecting the double bed in the front cabin can also serve as lee-sail: RIGGING Inner forestay and running backstays: We installed an extra forestay that can be used at two positions, but can also be removed (i.e. attached on the side, when the self tacking jib is in use). The attachments on the deck were reinforced with steel backings: one of the Wichard double padeyes is mounted close to the bow (with an under-deck backing plate and an extension to the steel plate on the bow)... ... and another is installed just in front of the large hatch (also with a backing plate and an under-deck extension onto the bulkhead separating the anchor-locker and the fore toilet): The length of the forestay is trimmed to the aft position (where it serves e.g. for a storm sail) and can be extended with an 0.5m extension for fixation at the fore position (for a working jib that can be projected out to weather with a pole). Running backstays were also mounted and can be attached on the coaming via padeyes that have been reinforced from under deck with steel plates: Heavy weather: an extreme 3rd reef was inserted into the main sail. It will be a two line reef: the aft line is preinstalled in the boom (at the expense of the topping lift, which is now operated at the mast; it will be attached to the 3rd reef cringle with an Antal snap hook, and can then be taken in with the winch from the cockpit. An 0.5m strap will connect the luff cringle with a Wichard eye on the mast. Other issues (energy, deckgear and water) will be dealt with in the next "topic". |
|
davidefoce
Lieutenant Joined: 14 February 2014 Location: Italy Status: Offline Points: 21 |
Post Options
Thanks(0)
|
You are crazy , but i ve appreciate your job, compliments!!!
|
|
The important is: Floating everytime
|
|
plattgatt
Captain Joined: 22 December 2010 Location: Germany Status: Offline Points: 175 |
Post Options
Thanks(0)
|
Perfekt!!
Perfect, in particular the 3/4 Reff, already tested?
|
|
370#641 "aqua d`or"
|
|
samba
Captain Joined: 24 December 2007 Location: Netherlands Status: Offline Points: 234 |
Post Options
Thanks(0)
|
Hello,
Thanks for sharing all your hard work. What is your (planned) sail plan? Cheers, Michiel
|
|
Samba - Hanse 411 - Bruinisse
|
|
superliga
Rear Admiral Joined: 25 April 2008 Location: Copenhagen Status: Offline Points: 590 |
Post Options
Thanks(0)
|
Very nice work and preparation.
I don't think your saloon table will be up to the job of holding a sleeping grown man on a port tack. Did you crawl your mast and inspect for cracks / stress signs?
|
|
PEARL - S/Y SUPERLIGA - HANSE 470 e - Hull #168 - hanse470.com
|
|
NIRVANA III
Sub Lieutenant Joined: 08 December 2014 Location: Spain Status: Offline Points: 12 |
Post Options
Thanks(0)
|
Hello from Spain Good work Kytho Very good ideas Now I am preparing the boat to cross the Atlantic and I will have to go well Thank you very much Edited by NIRVANA III - 08 December 2014 at 11:40 |
|
NIRVANA III
Sub Lieutenant Joined: 08 December 2014 Location: Spain Status: Offline Points: 12 |
Post Options
Thanks(0)
|
Hi Kytho Good afternoon Any questions? that halyard raise the sails. (jib and storm jib) Thank you |
|
sailkoop
Commadore Joined: 02 September 2010 Location: Germany Status: Offline Points: 437 |
Post Options
Thanks(0)
|
Hi Nirvana,
why you are using two Position for the inner forestay. Normally, you are running the with the Selftacker or an 105% Genua on the original forestay. The inner forestay is for a Jib 3 or a Stromsail. Can you explain me the reason why, please. |
|
best regards
Bjoern |
|
sailingmaster
Sub Lieutenant Joined: 27 January 2016 Location: Vladivostok Status: Offline Points: 3 |
Post Options
Thanks(0)
|
I'm sorry to ask, but what is this rust on the top? From where this rust coming? Hanse just put iron bolts? I would afraid to go on this boat around the world.
|
|
tDot
Sub Lieutenant Joined: 01 December 2016 Location: Vancouver, Cana Status: Offline Points: 8 |
Post Options
Thanks(0)
|
Hello Kytho,
Thank you for your very informative posts! It's great to see what other people are doing. I've purchased a 505, and I'm considering the pros/cons of some modifications similar to yours. Have you had a chance to use your 3rd reef in the main sail? Inner Forestay and storm sail? How well was the boat balanced with this setup? Was there anything that you did that you wouldn't do again? What were the items that you were happiest with? How have you found the solbian panels? Are they overly affected by shading in the configuration that you chose? Thanks Todd
|
|
Post Reply | Page 12> |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Links : www.hanseyachts.co.uk www.hanseyachts.com www.fjordboats.co.uk www.dehler.co.uk www.varianta.co.uk |