myHanse.com - Hanse Yacht Owners Website myHanse.com - Hanse Yacht Owners Website myHanse.com - Hanse Yacht Owners Website myHanse.com - Hanse Yacht Owners Website

Welcome to myHanse.com the forum for Hanse Yachts owners throughout the world.

Forum Home Forum Home > Hints and Tips > 411
  New Posts New Posts RSS Feed - Rudder bearing dimensions of the Hanse 411/2005
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Rudder bearing dimensions of the Hanse 411/2005

 Post Reply Post Reply Page  <12
Author
Message
H8jer View Drop Down
Admiral
Admiral


Joined: 14 September 2010
Location: Denmark
Status: Offline
Points: 1062
Post Options Post Options   Thanks (0) Thanks(0)   Quote H8jer Quote  Post ReplyReply Direct Link To This Post Posted: 03 July 2022 at 15:09
Hi Amarone


I don't understand that you have a rubber gaitor, because with self-aligning bearing, the tube is kept so tall that there would be no need for a rubber gaitor. The maintenance of a self-aligning bearing is also to pour fresh-water into the tube if the boat is to be stored on shore.
So the rubber gaitor indicate an old bearing house, but jefa has a pdf with spares with the self-aligning bearings - even with different measurements...

To be sure I think you would need to measure the diameter of the tube in which the lower rudder-bearing resides.
Either from the seaside or by removing the rubber gaitor.
Perhaps any 411 also from 2005 could help here?
I think my knowledge is not sufficient.
Kind Regards 


Hanse 370#487 30HP 3-cabin
Back to Top
 Post Reply Post Reply Page  <12
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.

This page was generated in 0.063 seconds.

Links : www.hanseyachts.co.uk www.hanseyachts.com www.fjordboats.co.uk www.dehler.co.uk www.varianta.co.uk